General information

  • Location address
    DÜSSELDORF
  • Location country
    Germany
  • Year of construction
    2006
  • Name of the client/building owner
    Insignium gebaute Marken GmbH
  • Function of building
    Exhibition
  • Degree of enclosure
    Fully enclosed structure
  • Climatic zone
    Temperate - cold winters and mild summers
  • Primary function of the tensile structure
    • Daylight gains
    • Rain protection
    • Space defining elements
    • Sun protection
    • Wind protection

Description

In September this year the so-called Meilenwerk, which has successfully been established in Berlin several years ago, has also been opened in Düsseldorf. On a surface of 19,000 m², a fascinating forum will be offered to all vintage car enthusiasts in North-Rhine Westphalia.

Apart from restaurants, event and shopping areas, there will be a large exhibition space, and workshop areas for vintage car and other vehicle enthusiasts on the listed premises of the former engine shed. Visitors will be able to see selected classical vehicles in museum-like areas, as well as a vivid trading centre for vintage cars.

Thanks to its roof structure, this area will also be an architectural attraction, since an area of approximately 2,500 m² will be protected by an exceptional transparent air cushion roof of ETFE films.

The following is a quotation from the press release from the Meilenwerk: "The air-filled chambers lie like a cushion between the steel braces, transforming the former track yard into an elegant platform. When you look up, you will be amazed by the impressive perspective: The run of the steel braces is bundled in the centre of the former turntable, where the restaurant is now situated. The incomparable architecture of the building is specially highlighted by the radial layout of the lines".

Due to the translucent, air-filled film cushions, the individual roof construction, made of steel trelliswork girders, easily attracts the observers' attention. Each cushion consists of 4 film layers each layer being printed in a different way, in order to enable only diffuse light to pass.

1st layer: ETFE film, 200µm, printed all over in silver;
2nd layer: ETFE film, 100µm, transparent;
3rd layer: ETFE film, 100µm, matt finished;
4th layer: ETFE film, 200µm, decorative blotch printing, silver.

Thus, visitors can enjoy the exhibition in a light and pleasant atmosphere without being blinded by direct sunlight. The light passage amounts to approximately 25%, including a large proportion of diffused light. Altogether, approximately 10,500 m² ETFE film was used in the Greven factory for the multi-layer cushions.

In case of snowfall, the permanent cushion pressure will be increased automatically from 300 Pa to 800 Pa. Thus, the construction can bear a snow pressure of 0.75kN/m².

After its successful assembly by CENO TEC engineers, the roof could be taken over by the customer according to schedule at the end of July.

The Meilenwerk Düsseldorf was inaugurated on the 16th and 17th of September 2006.

Description of the environmental conditions

Material of the cover

  • Cable-net/Fabric/Hybrid/Foil
    Foil
  • Material Fabric/Foil
    ETFE-foil

Main dimensions and form

  • Covered surface (m2)
    2500
  • Form single element
    Synclastic

Duration of use

  • Temporary or permanent structure
    Permanent

Editor